This is our new Church Window Brickwork Stencil for use with Fluffy Stuff or distress inks and our new Die cut Church Window Card Surround. It arrives pre coated with repositional adhesive and protective backing. Simply remove the backing sheet, smooth the sticky side of the stencil down on your card project or one of our new Die Cut Card Church Window Surrounds. Apply Fluffy Stuff, peel away the stencil leaving behind the brickwork, and heat the Fluffy Stuff with a heat gun. You will be amazed at the 3D effect once the brickwork puffs up. Or you can use distress inks instead of the Fluffy Stuff. Created for our Large Clear Hexagonal Display Box. We have uploaded a series of photographs to show how the stencil is used. Suitable for the New Church Font Keepsake Kit boxes as well as our Large Clear Hexagonal Display Box. Please Note: Make sure that you thoroughly clean the stencil between uses under clean slightly warm water. Don't worry about the sticky side, this will recover it's stick once dry. After a few uses, the sticky will gradually wear off and the Fluffy Stuff or distress ink will start to run under the stencil. Simply clean under water and once dry, respray the sticky side using Either Crafters Companion Stick and Spray or 3M Spray Mount Repositional Adhesive.